Posted on

making hash oil with isopropyl alcohol

Making hash oil with isopropyl alcohol

  • 7 to 10 grams of dried, coarsely ground marijuana (you can use bud or trimmed leaves)
  • Funnel (to fit strainer)
  • Wooden stirring spoon
  • Everclear 95% pure grain alcohol
  • Container for storage
  • Flameless hot eye
  • Clean blade
  • Coffee filters
  • 2 kitchen sink strainers
  • 8-ounce measuring cup
  • 1-quart glass jar (receptacle)

Now you need to boil off your alcohol so that you’re left with only your hash oil. You can do this without a heat source by putting the solution into a flat wide dish where the alcohol is allowed to evaporate over several hours. This will avoid the danger of concentrated alcohol fumes. Or, you can heat the mixture. To do this, set your burner slightly above the boiling point of ethanol, around 174 F, but below 230 F. These low temperatures will help you avoid fire. However, the fumes will be another issue. Be sure to do this in an open area with great ventilation and even avoid getting a strong whiff of fumes because a strong whiff of pure alcohol can quickly make you drunk or faint. You can use a double boiler so that the ethanol is not directly heated for added safety. You will see the solution bubbling, this means the alcohol is evaporating. Once the bubbling stops, the alcohol is all gone and you have pure hash oil left. Remove from heat. You will have a tarlike substance that may be hard or waxy. Remove immediately to your storage container while the wax is easy to work with. Total heating time for about 8 grams of weed to make 1.5 grams of hash oil may take less than 15 minutes to evaporate out the alcohol. You can use a blade to scratch the stain from the coffee filter, the result is pure kief (trichomes) you can use for other projects. Discard the used trim or buds. Your hash oil will stay potent for up to a year. Now you know how to make weed oil to smoke the easiest way.
At this point, you have the alcohol and cannabinoids dissolved in your jar. Remember the alcohol is flammable so keep away from flames.

For the cleanest results, you can freeze your marijuana and Everclear in the freezer to prevent the less tasty chemicals from being extracted. Set up in an open area with proper ventilation, to avoid concentrated fumes. To begin, first, put together your apparatus to strain and catch your hash oil mixture. Take your two strainers and put the coffee filter into one then place the other right inside so that the coffee filter is sandwiched in between the two strainers. Set the strainers into the funnel, then put the funnel into your jar. Now you have your strainer ready. If you don’t have all the tools or are missing a strainer, don’t worry. This step is no more than straining the mixture, do it any way you can as long as you use safety protocols and strain out the plant material. Remember alcohol can dissolve chemicals from plastics and fabrics, so try to use cleaner, more resilient tools, such as glass, ceramic, or stainless steel.
Tools and Utensils:
Here are the materials you will need:
Some experts advise not to let the alcohol touch metals other than stainless steel, any kinds of plastic or rubber, or other materials which may leech into the alcohol. This is sound advice. Chemicals used in processing plastics, as well as heavy metals, can give your hash oil a bad taste, or worse, reduce the health potential of your medicinal hash oil. Lastly, some hash oil is produced to be consumed and the alcohol that comes into contact with metals like copper could remove some of that copper and deposit it into your hash oil, making it far less healthy.
Step 5. Remove hash oil to the storage container.
It’s important to use a double boiler or rice cooker to heat your solution to avoid applying heat directly to pure grain alcohol. If you don’t have a double boiler, you can make your own. You can do this by taking a pot and filling it a fourth with water. Bring this to a boil, then reduce the heat to a simmer. Find a strong glass bowl that fits over the top of the pot while leaving at least 3 inches between the solution and the bowl. Now you can use this bowl to evaporate out the alcohol from the THC and cannabinoids, being careful to avoid the fumes and keep the ventilation open so that alcohol fumes do not accumulate which can cause unconsciousness, drunkenness or a fire.

Hash oil making can be a delight with an easy hash oil recipe. We will list, step-by-step, the easiest way to make hash oil. You will learn how to make homemade hash oil in a short amount of time. Hash oil can be used to make your weed stronger, and to put unusable weed to work for you instead of letting it go to waste.

Sure, you could just buy some hash oil, or you could brew up a batch of hash oil yourself right in your own home! Don't you know how to make it, here are we going to teach you. Don't worry, step-by-step guide will help you achieve everything! Hash oil making can be a delight with an easy cannabis edible recipe!

BE SURE YOU DO NOT GET DENATURED ALCOHOL. Denatured alcohol contains ingredients that can be POISON. “Denaturing” is a process where they add ingredients to make the alcohol unsuitable for human consumption. If you use “denatured” alcohol, you will wind up with hashish that is unsafe to consume, and it will probably taste terrible, too.

Step 4. Filter out the plant fiber
Do you have some weed laying around that wasn’t good enough to smoke? This method will salvage whatever can be salvaged from lousy weed, greatly improve its potency, and even turn bunk into something that is useful (for emergencies, anyway)..

If you cannot find alcohol in your drug store, you can also use any high-alcohol content rum or vodka, such as Everclear. If you are going to use rum or vodka you should note that the alcoholic beverage may contain additional ingredients that may modify the flavor of the resulting hashish, or make it harsher to smoke. Plain alcohol is to be preferred, and plain alcohol is cheaper.
Step 6. Enjoying the result
Pouring it over other marijuana
Step 3. Soak the marijuana in alcohol
How to make hashish, increase the potency of your marijuana, and salvage bad weed that was unfit to smoke.

Some other methods recommend heating the mixture on the stove to evaporate off the alcohol. This can be dangerous , as described above. It is far better to just be patient and let the alcohol evaporate naturally. It takes a little longer, but it is far safer and a lot less work.

Making hash oil with isopropyl alcohol How to make hashish, increase the potency of your marijuana, and salvage bad weed that was unfit to smoke. Do you want to know how to make hash the