Posted on

dr autoflower

Start at a low dose and watch the plant over a few days for nute burn.

PH Tap Water – general hydroponics ph down

  • Mix/Shake well to help oxygenate the water.
  • Step 4 – Run the same Clearex/water through again.

    Rotate Plants 180* every 48-72 Hours for Entire Late Veg/Flowering grow.

    Step 2 – Run this mix through your plants. If you are doing containers you want to achieve significant runoff. Far more than your standard watering. The bottle calls for AT LEAST 80-90% runoff. So if you have a 5 gallon pot, you will want to put 3-6 Gallons of water through depending on how dry the soil is when you flush, and how much drainage. With a little experience with your soil you can skip the rest of the steps and call it done right there. If you really want to be sure then use the ppm measuring described below.
    2. When you dramatically change the nutrient schedule– usually when you start Flowering, some flush entering Veg as well. This is a preventative flush. Again – not mandatory, but not a bad idea. Also, in soil, this is about the time the plants have sucked all the nutes from the soil, And before you go jacking it up with your own mix – its not a bad idea to sort of zero it out.
    Copper
    Copper gets locked out of soil growing at ph levels of 2.0- 4.5
    Copper is absorbed best in soil at a ph level of 5.0-7.5

  • Topping: – Right before the pistils show (pre sex) If needed to keep the plant short.
  • Auto flower Grow Guide Seedling Stage: 3 or 5 Gallon Pots: Fox Farm Ocean Forest 75% & 25% Perlite Mix. Weight Pots When Dry & Saturated ( write…